IMPACT RAMMER VMR60, VMR75 (OP. MANUAL)
$30.00
OPERATOR MANUAL FOR JCB IMPACT RAMMER VMR60, VMR75.
PN: 332/A5755.
Published: ISSUE 2 – JULY 2009.
Languages: English, French, German, Spanish, Italian, Portuguese, Dutch, Russian.
Total Pages 354.
Description
IMPACT RAMMER VMR60, VMR75 (OP. MANUAL)
Machine Model and Serial Number
This manual is for IMPACT RAMMER VMR60, VMR75. It provides information for the following model(s) in the JCB machine range:
– VMR60 from serial number 1233000
– VMR75 from serial number 1233000
Using this Manual
This manual is arranged to give you a good understanding of the machine and its safe operation. It also contains maintenance information and specification data. Read this manual from front to back before using the machine for the
first time. Particular attention must be given to all the safety aspects of operating and maintaining the machine. Do not operate the machine without an Operator Manual.
Treat the Operator Manual as part of the machine. Keep it clean and in good condition. Replace the Operator Manual immediately if it is lost, damaged or becomes unreadable. If there is anything you are not sure abo ut, ask your JCB distributor or employer. Do not guess, you or others could be killed or seriously injured.
General warnings in this chapter are repeated throughout the book, as well as specific warnings. Read all the safety statements regularly, so you do not forget them. Remember that the best operators are the safest operators.
Operating Practices
The following instructions should be observed under all circumstances during operation of the IMPACT RAMMER VMR60, VMR75:
– When moving the machine, keep it under control at all times. Stay alert for obstructions and possible hazards.
– The machine operator must not leave the machine unattended.
– Due to its method of operation, the rammer causes vibrations and shocks in the ground. The user must make sure that building structures, pipes and other facilities in the vicinity are not damaged by the vibrations.
– Refuel only with the engine switched off.
– Operation of the rammer on rock, concrete or any other firm, non-compactible ground is forbidden.
– If you find a defect in the operating or safety equipment, then you must stop the rammer immediately.
Introduction
This section explains some techniques and procedures for using the machine efficiently and safely.However, there are a wide variety of situations in which your machine may be used. Consequently, in all cases, the applicability of these notes must be determined by the person seeking to apply them, on the basis of his/her own judgement, in the light of the conditions in which use is intended and subject to all relevant statutory requirements.
The information in this section is given in good faith and in light of the best information available, JCB can accept no responsibility for the recommendations, advice, statements, opinions and conclusions expressly or by implication set out below and gives no warranty or representation of assurance in respect of the accuracy of the same.
Make sure that you have had adequate training and that you are confident in your ability to operate the machine safely before you use it. With a careful, well trained and experienced operator, your machine is a safe and efficient machine. With an inexperienced or careless operator, it can be dangerous. Do not put your life, or the lives of others, at risk by using the machine irresponsibly.
Find more manuals for JCB Industrial machines here.
Link to JCB Construction website is here.
Reviews
There are no reviews yet.