Description

JCB FORK MOUNTED HOOK (OPERATION MANUAL)

About the manual

The JCB Fork Mounted Hook allows the Loadall to carry slung loads with safety. It incorporates a swivel hook with a spring-loaded safety catch. This attachment is supplied with test certificates for its fabrication and its hook. Its Safe Working Load is stamped on a plate mounted on the attachment.

Do not attempt to install, operate or maintain any attachment until you have read and understood all relevant operator documentation for both the attachment, and the carrier machine. Pay particular attention to safety information. You must observe all relevant laws and regulations. The manufacturer’s policy is one of continuous improvement. The right to change the specification of the machine without notice is reserved. No responsibility will be accepted for discrepancies which may occur between specifications of the machine and the descriptions contained in this publication.

The manufacturer’s policy is one of continuous improvement. The right to change the specification of the machine without notice is reserved. No responsibility will be accepted for discrepancies which may occur between specifications of the machine and the descriptions contained in this publication.

Carrier Machine Suitability

The JCB Fork Mounted Hook is suitable for use with the JCB loadall machines.

Installation

1 Space the forks equally on either side of the machine centre line, so that the mounting sockets A can be installed onto them.
2 Fully tighten the fork clamping screws to prevent movement.
3 Remove lynch pin B and locking bar C.
4 Slide the attachment over the forks so that the rear of the attachment butts against the heels of the forks.
5 Reinstall the locking bar C and secure with lynch pin B.
6 Make sure that both mounting brackets are installed securely.

Find more manuals for JCB Industrial machines here.

Link to JCB Construction website is here.